Comparing The Edited Effect Program With The Original - Yamaha GW33 Owner's Manual

Comparing the Edited Effect Program with the Original

You can compare the sound of the newly edited program
with the sound of the original one. To do this, press the
e button again (so that the EDIT/COM-
PARE lamp flashes).
EDIT/
COMPARE
In this condition, you can hear the sound of the original
effect program. You can also view the original parameter
values by selecting the desired effect block with the
y or n buttons and turning the Parameter
Dials. Doing this doesn't change the value, it simply
displays it so that you can check it against the value
you've edited.
Each press of the e button switches back
and forth between the original program (lamp flashes) and
your new edits (lamp lights continuously).
When you've adjusted the sound to your satisfaction, you
may wish to save it for future recall. You can either copy
the settings down on paper (using a copy of the Blank
Effect Parameter Chart on page 38) or go on to the next
section and save the settings to the GW33's memory.
14
1 2
1 2 1 2
1 2
1 2
1 2 1 2
1 2
1 2 1 2
1 2
1 2
1 2 1 2
1 2
1 2
1 2 1 2
1 2
1 2
1 2 1 2
1 2
EDIT/
1 2
1 2 1 2
COMPARE
1 2
1 2
1 2 1 2
1 2
1 2
1 2 1 2
1 2
1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2 1 2
1 2
Be careful not to press the p
CAUTION!
button while editing. If you do, the original effect
program's settings will be called up, erasing all
settings you had made to that point.