Digital Effect Program List (Only Mw8Cx); Mounting To A Microphone Stand - Yamaha MW8cx Owner's Manual

Digital Effect Program List (Only MW8CX)

No Program
1 REVERB HALL 1
2 REVERB HALL 2
3 REVERB ROOM 1
4 REVERB ROOM 2
5 REVERB STAGE 1
6 REVERB STAGE 2
7 REVERB PLATE
8 DRUM AMBIENCE
9 KARAOKE ECHO
10 VOCAL ECHO
11 CHORUS 1
12 CHORUS 2
13 FLANGER
14 PHASER
15 AUTO WAH
16 DISTORTION
* "LFO" stands for Low Frequency Oscillator. An LFO is normally used to modulate another signal, determining the modulation speed and
waveform shape.

Mounting to a Microphone Stand

• When using the mixer on a microphone stand,
be sure to set the stand on a level and stable
surface. Do not set up the stand in locations
CAUTION
subject to vibrations or wind.
• Note that mixer may be damaged if the stand
should fall over. Attach the connection cables
carefully so that the cables will not catch on the
equipment and cause it to fall. For example:
arrange the cables so that they run parallel with
the microphone pole down to the base of the
stand.
• Leave ample free space around the stand.
1
Turn the mixer upside-down, and hold the
microphone-stand adaptor (BMS-10A; sold sep-
arately) against the bottom of the mixer so that
the screw holes are aligned (q).
Screw the adaptor firmly into place with the two
screws (w).
Parameter
REVERB TIME
Reverb simulating a large space such as a concert hall.
REVERB TIME
REVERB TIME
Reverb simulating the acoustics of a small space (room).
REVERB TIME
REVERB TIME
Reverb simulating a large stage.
REVERB TIME
REVERB TIME Simulation of a metal-plate reverb unit, producing a more hard-edged sound.
REVERB TIME A short reverb that is ideal for use with kick drum.
DELAY TIME Echo designed for karaoke (sing-along) applications.
DELAY TIME Echo suitable for vocals.
LFO Frequency Creates a thick sound by modulating the delay time.
The PARAMETER control adjusts the frequency of the LFO* that modulates the
LFO Frequency
delay time.
A sweeping pitched effect.
LFO Frequency The PARAMETER control adjusts the frequency of the LFO* that modulates the
delay time.
Phase modulation produces a cyclical phasing effect.
LFO Frequency The PARAMETER control adjusts the frequency of the LFO* that modulates the
delay time.
A wah-wah effect with cyclical filter modulation.
LFO Frequency The PARAMETER control adjusts the frequency of the LFO* that modulates the
delay time.
DRIVE Adds a sharp-edged distortion to the sound.
Description
2
Turn the mixer right-side up, and mount it onto
your microphone stand.
3
Loosen the angle adjustment wingnut (q),
adjust the mixer's angle as desired (w), and
then tighten the wingnut securely (e).
For more information, refer to the BMS-10A Owner's Manual.
MW8CX/MW10C Owner's Manual
Reference
Front & Rear Panels
21