Advertisement
2
ASSEMBLY
1. See Figure 2. Attach Guide Plate ( I ) to Guide Bar (E) with
two Phillips Head Screws (H)
2. Fit Miter Guide assembly into the table saw miter track. This
Miter Guide can be set in either a right or left miter track.
3. Using a 2.5 mm Hex Wrench (included) adjust the Expansion
Discs (G) on each end of the Guide Bar for a snug but not
tight fit. Tighten or loosen as needed. Guide Bar should glide
smoothly in the miter track.
2
Figure 2
4. See Figure 3. Place the Body Assembly (A) onto the end of
Guide Bar (E) Match up the slots on the Body Assembly with
the two predrilled holes in the Guide Bar.
5. Use two Phillips Head Screws (H) to secure the Body
Assembly to the Guide Bar.
6. Use a square to verify the body is perpendicular to guide bar.
7. Ensure assembly slides smoothly in the miter track.
Figure 3
ASSEMBLY
Assemble the Adjustment Mechanism:
1. See Figure 4-5. To assemble the Adjustment Mechanism (O)
take Adjustable Stop Plate (P) align with holes on the inset
of the Adjustment Mechanism and secure with two Phillips
Head Tapping Screws M3.5x8L (Q).
2. Align Fixed Stop Plate (R) to the outside holes on the
Adjustment Mechanism (O) and secure with two Phillips Head
Tapping Screws M3.5x8L (Q). Add Adjustment Knob (M) to
adjustment post.
Figure 4
3. See Figures 6-7. Slide 1-1/2"T-Bolt (N) into left slot on the
back of the fence. Move T-Bolt to center cutout in fence.
Matching up T-Bolt and hole in the body of Adjustment
Mechanism (O). push Adjustment Mechanism onto the
T-Bolt. Twist Knurled Knob (K) onto the T-Bolt but do not
tighten at this time.
4. Take Acrylic Blade Guard (S) and align predrilled holes with
two holes in center top of the fence. Using two Phillips Head
Screws (H) secure Acrylic Blade Guard to fence.
Figure 6
Figure 5
Figure 7
Advertisement
