Advertisement
• A guard or any other part that is damaged should be properly
repaired or replaced. Do not perform makeshift repairs.
• Use the right tool for your job. Do not force your tool to do a
job for which it was not designed.
• Use safety equipment such as featherboards, push sticks and
push blocks, etc., when appropriate.
• Maintain proper footing at all times and do not overreach.
• Do not use the router table as a step or seat.
WARNING
To avoid serious injury, turn off and unplug the machine before
attaching or changing accessories or adjusting the cutter
height/fence position.
CAUTION
Think safety! Safety is a combination of operator common sense
and alertness at all times when tool is being used.
WARNING
Do not use the Box Joint Jig until it is completely assembled and
you have read and understood this entire operating manual and the
operating manual of the tool being used with this Box Joint Jig.
UNPACKING
Refer to Figure 1
Check for shipping damage. Check immediately whether all
parts and accessories are included.
ITEM DESCRIPTION
A
Body Assembly
B
1/4"-20 Hex Nut
C
MDF Sub Fence
D
Flat Head Phillips Screw 1/4"-20 x 5/8"
E
Guide Bar
F
Flat Head Phillips Screw M4 x 8L
G
Extra Expansion Discs
H
Phillips Head Screw
I
Guide Plate
J
T-Bolt 1/4"-20 x 2-1/2" L
K
Knurled Knob
L
Clamp Guard
M
Adjustment Knob
N
T-Bolt 1/4"-20 x 1-1/2" L
O
Adjustment Mechanism
P
Adjustable Stop Plate
Phillips Cross Recessed
Q
Round Head Tapping Screw M3.5x8L
R
Fixed Stop Plate
S
Acrylic Safety Blade Guard
T
2.5 mm Hex Wrench
SAVE ALL WARNINGS AND INSTRUCTIONS
FOR FUTURE REFERENCE
PARTS AND CONTENT
QTY
1
2
1
2
1
2
2
6
1
2
3
1
1
1
1
1
4
1
1
1
SPECIFIC SAFETY RULES
DANGER
To avoid serious injury, keep hands and fingers away from the
spinning blades or router bits. Be aware of the cutting apparatus
at all times.
WARNING
Turn off and unplug machine before installing or adjusting the bit
or adjusting the Box Joint Jig and accessories.
BEFORE beginning any cutting operation, ALWAYS make sure
ALL knobs on the Box Joint Jig and accessories are tightened
and the fence will not shift during use.
BEFORE plugging in and turning on the machine, ALWAYS
make sure the MDF adjustable fence faces are fully secured
and the cutting apparatus can rotate freely without touching the
fence faces.
WARNING
When adjusting the position of the Box Joint Jig do not allow the
metal blade/bit to come in contact with any metal portion of the
Box Joint Jig.
Figure 1
WARNING
Do not use the Box Joint Jig until it is completely assembled and
you have read and understood this entire operating manual and the
operating manual of the tool being used with this Box Joint Jig.
1
1
1
1
Advertisement
