Advertisement
TABLE OF CONTENTS
SECTION
SAFETY RULES
Safety Rules
PARTS AND CONTENTS
Unpacking
ASSEMBLY
Assembly
OPERATION
Operation
Adjustments
MAINTENANCE
General Maintenance
WARRANTY
Warranty
PRODUCT SPECIFICATIONS
RECOMMENDED SPEEDS
BIT DIAMETER
Up to 1" (25 mm) . . . . . . . . . . . . . . . . . . . . . .22,000 -24,000 rpm
1" to 2" (25 mm–51 mm) . . . . . . . . . . . . . . . . 18,000-22,000 rpm
2" to 2-1/2" (51 mm–64 mm) . . . . . . . . . . . . 12,000-16,000 rpm
2-1/2" to 3-1/2" (64 mm–89 mm) . . . . . . . . . . 8,000-12,000 rpm
NOTE: Always follow bit manufacturer's speed
recommendations. Some bit designs require specific speeds
for safety or performance.
PAGE
For your own safety, read all of the rules and precautions before
operating tool.
0-1
Always follow proper operating procedures as defined in this
manual even if you are familiar with use of this Box Joint Jig
or any tool used with this Box Joint Jig. Remember that being
1
careless for even a fraction of a second can result in severe
personal injury.
Before using another tool with this product, always read,
understand and follow the instructions and safety warnings in
the owner's manual for that tool. If you do not have the owner's
2
manual, obtain one from the tool's manufacturer before using it
with this product.
You must be familiar with the use of any tool or accessory used
with this Box Joint Jig. The supplier cannot be held responsible
for any accident, injury or damage incurred while using this Box
Joint Jig with any tool.
3-5
It is the responsibility of the purchaser of this product to
ensure that any person using this product reads and complies
with all instructions and safety precautions outlined in this
manual prior to use.
5
Some dust created by operation of power tool can expose
you to chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm. To reduce your
exposure to these chemicals, work in a well ventilated area and
work with approved safety equipment. Always wear OSHA/
NIOSH approved, properly fitting face mask or respirator when
6
using such tools.
Do not modify or use this Box Joint Jig for any application other
than that for which it was designed.
FOLLOW ALL STANDARD SHOP SAFETY
PRECAUTIONS, INCLUDING:
• Keep children and visitors at a safe distance from work area.
• Keep work area clean. Cluttered work areas invite accidents.
Work area should be properly lit.
MAXIMUM SPEED
• Do not use power tools in dangerous environments. Do not
use power tools in damp or wet locations. Do not expose
power tools to rain.
• Wear proper apparel. Do not wear loose clothing, gloves,
neckties, rings, bracelets or other jewelry which may get
caught in moving parts of the tool.
• Wear protective hair covering to contain long hair.
• Wear safety shoes with non-slip soles.
• Wear safety glasses complying with United States ANSI
Z87.1. Everyday glasses have only impact resistant lenses.
They are NOT safety glasses.
• Wear face mask or dust mask if operation is dusty.
• Be alert and think clearly. Never operate power tools when tired,
intoxicated or when taking medications that cause drowsiness.
SAFETY RULES
WARNING
WARNING
WARNING
CAUTION
Advertisement
