Table of Contents
Advertisement
Error Codes
Errors are indicated on the NOVA Eclipse Horizontal Bandsaw by the HMI screen displaying "Er" followed by the error code.
Example:
The motor is stopped when an error is displayed on the screen.
The table below shows the possible error codes which can be displayed.
If an error code is displayed and bandsaw becomes unusable, please contact our customer services along with the error code that is being
displayed.
NOVA Customer Services: For any electrical and motor related issues, please contact NOVA Customer Service: service@teknatool.com (All
enquiries must be in writing). If this is a warranty issue, please include copy of proof of purchase along with all contact information.
Firmware- Updating DVR firmware
1. Turn off bandsaw.
2. Visit website https://www.teknatool.com/upgrade-your-firmware/.
3. Choose NOVA Eclipse, and follow instructions.
4. Download and install NOVA firmware update software.
5. Download NOVA Eclipse firmware.
Note: This software and firmware are only compatible with Windows operating systems (PC).
6. Connect provided USB cable to your PC and connect other end to the right side of the DVR control panel and wait approximately 5 seconds
until the screen displays "USB".
7. Launch the NOVA firmware update software, retrieve and open firmware file, select "Upgrade".
Error code
Error Description
01
Over Voltage
02
Over Current
03
Motor running too fast
04
Motor not starting
05
Rotation position sensor error
06
Motor too hot
07
Main control board too hot
E.StP
E-Stop is pressed in and needs to be deactivated to run
ERROR CODES & FIRMWARE
Advertisement
Table of Contents
