Yamaha DX200 Owner's Manual page 77

Transmit DX200 Bulk Dump Data
This is used for directly transmitting the current DX200 Editor pattern data as MIDI bulk
dump data to the DX200. To use this, highlight the command in the menu, then click.
• When you want to store the data to the User Pattern memory of the DX200, the Memory Pro-
tect should be turned "Off."
• Transmit Method
1 Pattern
When this is selected, only the data for the currently selected pattern will be transmitted.
User Patterns
When this is selected, User patterns will be transmitted.
Bulk Dump Interval
Range: 0msec ... 1.5sec
This parameter is available when "User Patterns" above is selected. Bulk Dump Interval
determines the amount of time (in clocks) that separates each data transmission. If the
DX200 "chokes" on the incoming MIDI data, or DX200 Editor has trouble sending all the
data properly, or some other trouble occurs, try setting the Interval to a higher number.
• Transmit DX200 Bulk Dump
Start
First, click this button to start transmission of the data. Then start transmitting the bulk data.
• OK
Click this to exit from the dialog box once all data has been transmitted.
• "Transmit DX200 Bulk Dump Data" can also be selected from the toolbar.
Setup Menus /
77
Transmit DX200 Bulk Dump Data