Pre-Filter Removal For Cleaning And Replacement - Lincoln Electric PRISM CENTRAL SYSTEM 2 Operator's Manual

PRISM CENTRAL SYSTEM 2
®
PRE-FILTER REMOVAL FOR CLEANING
AND REPLACEMENT
Before servicing, unit must be off and the power
switch on the control panel turned to the off position.
Unlock the door latches using the supplied hex tool or any 5/16"
hex wrench, then open the door.
1. Remove the pre-filter brackets
c. Lift bracket up off of base hinge and
remove bracket from unit.
d. Repeat for the upper bracket.
NOTE: Graphics shown with door and one cartridge filter
removed for clarity only. Removal is not required.
a. Loosen lower bracket's screw knob.
b. Rotate bracket on rear hinge.
e. Pull pre-filters out of side panel pocket.
f. Remove through door opening.
g. Clean or dispose of pre-filters in accordance
with all federal, state and/or local guidelines.
MAINTENANCE
h. Install lower filter into lower bracket in side
pocket. Make sure filter's upper bracket
flange is against the side of the housing as
shown.
i. Install upper filter above lower filter.
j. Reinstall filter brackets in reverse order from
removal.