Yamaha DTXTREME Owner's Manual page 49

8. Set the quantization level
n Quantization is used to correct timing inaccuracies and the note length specified here is the resolution to
which the notes will be corrected during recording. In general, this is usually set to the minimum note
length in the performance. If quantization is switched off, your performance will be recorded without any
timing corrections. In this case, you can also apply quantization to your recording later in Song Job mode.
9. Start recording
10. Play the drums
11. Stop the recording
n If you set the recording mode to "Replace," the recording will stop at the end of the specified number of
measures.
CLICK
TAP GROOVE CHECK
49