Maintenance; Loss Of Warranty Claims; Warning Of Residual Risks - deconta G 600 Instruction Manual

9

Maintenance

This section contains information for the safe maintenance of the machine.
Maintenance includes all technical and organisational measures during the life cycle of the
machine to ensure the safe, economical and functional condition of the machine and to
prevent environmental damage.
9.1

Loss of warranty claims

The manufacturer's warranty will expire in the following cases:
•
In the event of modifications to the machine that have not been agreed with the
manufacturer
•
If maintenance is not carried out properly
9.2 Maintenance
Maintenance work, including changing / removing the filters, may only be carried out by
authorised persons wearing suitable protective clothing.
For all repair and maintenance work, the unit must be completely disconnected from the
power supply.
We expressly refer to possible additional regional and national regulations when
maintaining the appliance technology.
The ventilation systems (dust extractors, industrial hoovers and devices used for ventilation
or vacuum maintenance) must be maintained as required, but at least once a year, repaired
if necessary and inspected by an equipment expert. The test result must be presented on
request.
Units with SRE connect control should be checked and calibrated once a year by
deconta service.
9.3

Warning of residual risks

Negative pressure unit green dec G 600, G 700
Original operating instructions
Contaminated filters may only be changed in compliance
with all relevant safety precautions.
Change filters only when the unit is switched off. Only use
approved filters.
Do not use residual fibre binders on the unit.
Pull out the mains plug before opening the housing
Maintenance
45 from 62
Version 1