Advertisement
Pre-sweep suction unit installation
2.2.1 Check settings:
If the pre-sweep suction unit is attached
to the machine and the lever is in the
sweeping position (Pos. 1) (Fig. 3/1),
the frame must be aligned parallel to
the floor.
2.2.2 Correct setting:
If this is not the case, the following steps
must be taken:
1. Disconnect the pre-sweep suction
unit.
2. Unscrew the swivel bracket
(Fig. 3/2) from the machine. The tilt
angle of the frame is determined by
adding or removing the washers
(Fig. 3/3). The following applies: the
more the washers are used, the
more the frame will tilt downwards at
the front.
8
1
With overhead guard
3
Fig. 3
1
Without overhead guard
2
3
2
Advertisement
