Signal Strength - Simons Voss Technologies RouterNode 2 SmartBridge Quick Manual

6. Initial operation
System 3060:
RouterNode 2
MobileKey:
SmartBridge
SmartIntego:
Gate-
wayNode 2

6.1 Signal strength

Measure sig-
nal strength
38 / 152
LSM must be able to communicate with RouterNode
2. The connection between LSM and RouterNode 2 is
established by using the WaveNet Manager. For
details, please refer to the manuals for RouterNode 2,
WaveNet and WaveNet Manager.
You can manage network-compatible locks wirelessly
in MobileKey with the SmartBridge. To do this, set up
at least one SmartBridge via the MobileKey interface.
Please refer to the MobileKey and SmartBridge
manuals for details.
You can manage network-compatible locks in
SmartIntego wirelessly with GatewayNode 2. Please
refer to the SmartIntego technical manual for details.
Signal strength, as with all radio devices, depends on
several factors, including:
Centres distance

Structural conditions (e.g. metal surfaces or

reinforced concrete as building material)
Other transmitters in the 868 MHz range (e.g.

wireless microphones or garage door openers)
If you are not satisfied with the operational safety, you
can change the installation location or use an external
antenna (see manual).
You can measure the signal strength of the device with
a measuring device (BAMO tester). If you would like to
use a BAMO tester, you can obtain it from SimonsVoss
Technologies GmbH with the article number
RouterNode 2 SmartBridge
EN