Chain Suspension Mounting - Hatco Glo-Ray GRAIH Series Installation And Operating Manual

English
Two adjustable
angle brackets
on each end
for dual units.
Dual Unit Mounting

Chain Suspension Mounting

Mounting a unit with chain suspension attaches the unit to an
overhead surface with the use of "S" hooks.
NOTE: Units ordered with the "S" hook option come with two "S"
hooks and two 152 mm (6") lengths of chain. Additional
chain (P/N 05.03.020.00) can be ordered from Hatco
for the overhead mounting system or another option
can be determined by a qualified installer.
WARNING
For installation with chains, make sure the chains have
sufficient strength and are securely fastened to both the
unit and the mounting location. Poorly installed chains
may cause the unit to loosen and fall. Do not place
anything on top of units installed with chains.
Ensure safe and proper operation. Refer to the "Minimum
Clearance Requirements" listed in the Installation section
of this manual.
NOTE: The strength of the chain supplied by Hatco is sufficient
to hold the weight of the unit securely only when
mounted properly.
1. Prepare the overhead mounting system for the "S" hooks.
Make sure the system is secure and is set up so the unit
will be suspended at a level, safe, and proper distance
from walls, counter, and food.
2. Loosen, but do not remove the screws securing the hanger
tabs on each end of the unit. Rotate the tabs up, then
tighten the screws securely.
3. Securely attach one of the 152 mm (6") connecting chains
between each pair of hanger tabs.
4. Attach an "S" hook to the center of each connecting chain.
5. Carefully lift the unit and attach the "S" hooks on each end
of the unit to the overhead mounting system. Make sure
the unit is level.
Form No. GRAIH_AAM-0117
Overhead Mounting
System
"S" Hook Mounting
11
INSTALLATION
"S" Hook
Connecting Chain
Hanger Tab
Screw