A
SSEMBLY
7.3 Bending and mounting the water level mark
If the water level mark is not already mounted but is included with the gauge including screws,
it must be bent as described below and mounted on the clamping tabs at the specified height.
Bending the water level mark
Figure 1
• Place the flat water level mark on the back
• Bend up the mounting bracket up by 90° to the right.
Figure 2
• Bend the text field upwards by 90°
Mounting the water level mark
Components
Designation
Water level mark bent by
hand
Thread-forming screw M3 x
6, case-hardened steel
Tools
Designation
Marker
Grain
Fitter's hammer
HSS Twist Drills
Hand Deburring
Screwdriver
Page / 14
Fig.1
Figure
Figure
Fig.2
Amount
1
2
Recommended size
0.6 mm linewidth
4mm lace width
500g
Ø 2.8 mm
Ø 12.4 mm
TX10
D-02-B-51105-EN-02