Kenwood L-07D Instruction Manual page 8

5 Installation of the turntable
For the place where the turntable and control
unit are to be installed, refer to page 14. At this
time, the tonearm retaining band used in
transportation must still be in place.
6 Connection of the power cord, control and
audio cables
Confirm that all the power switches of the
control unit and amplifier are turned OFF. Con-
nect the cables as follows.
1 Connect the control cord to the connector
located at the rear of the turntable. As
shown in Fig. 9, the connector has two
different type grooves and bosses and is
of a screw lock type. Insert correctly and
tighten the screw to lock the connector.
2. Connect the attached ground wire to the
GND terminal of the contro! unit and
ground terminal of the amplifier.
3. Connect the audio cable to the PHONO
terminal of the amplifier and connect the
ground cable to the ground terminal
4. Connect the power cord to a wall outlet or
the AC outlet of the amplifier
Control unit
Power cord
ie ]
To AC outlet
= WKS | aa
Stereo amplifier
or receiver
Fig. 9
7 Installation of plug-in head
After inserting the plug-in head, tighten it
securely as shown in the figure below.
Align the pin with
the slot and insert
Fig. 10
8 Adjustment of turntable level
Adjust the four insulators while observing the
level gauge.
EIGHT ADJUST RANG
8 L-o7DIK)