Cartridge Installation - Kenwood L-07D Instruction Manual

HOW TO ATTACH
THE CARTRIDGE
If the weight of the plug-in head ore €
with cartridge) exceeds 21 g {when a car-
tridge heavier than 9 g is used together with
the supplied head-sheil), attach the sub-
weight at the rear of the main weight as
shown in Fig. 21 and adjust the stylus
pressure. In this case, the counterweight
scale is changed. Use the following conver-
sion table to obtain the specified stylus
pressure
To =
attach the
sub-weight
Fig. 21
Indicatio
the counter
dial
Actual
stylus
pressure
n of
12/14
0
8 ta]
151175) 20 |226;25
Unit: g
mae
CARTRIDGE INSTALLATION
This turntable is not equipped with a car-
tridge. Attach your cartridge as follows
All head-shells that conform to EIA standards
can be attached to this tonearm However,
use a carefully selected head-shell to obtain
good sound quality
Weights of cartridges and head-shells vary
With this turntable, the total weight of the
cartridge and head-shell can range from
13~34g.
Fixing screws —————*}
T
Washers ————+& §
<
Finger —-———_—_
Head-sheli body —*|
Cartridge —————|
Ne White Liat
; Red +
Fig. 22
The length of screws: 10, 15 and 22 mm are
provided. Use the correct screw in the correct
positions.
To facilitate overhang adjustment, tighten the
fixing screws lightly.
When using a low output MC type cartridge or
a special type of cartridge, refer to the car-
tridge instruction manual for connection.
NOTE:
Before removing the plug-in head, clamp the
tonearm to the arm rest, reduce the amplifier
output to minimum or turn the power OFF. When
removing the plug-in head, take care not to apply
excessive force to the tonearm.
au
yy
L-O7 DIK)
11