Power Frequency; Before Assembly - Kenwood L-07D Instruction Manual

2. To reset the selector, slide the stopper plate
to the opposite side with a screwdriver or
other pointed tool. See Fig. 1-2
3. Insert the power cord securely. See Fig 1-3.
* Our warranty does not cover damage caused
by excessive line voltage due to the improper
setting of the AC Voitage Selector.
POWER FREQUENCY
* This turntable is driven by a DC motor, and
will work equally well on 50 Hz or 60 Hz
power frequencies.
BEFORE ASSEMBLY
The L-O7D is separated and packed in two
cartons. Unpack these cartons and check the
number of components refering to the following
list and ''PARTS NOMENCLATURE" on page 6
To assemble the turntable, follow the se-
quence of steps on page 7
© Carton 1: Phonomotor and turntable base
Turntable cabinet
Turntable platter
Turntable sheet
Turntable platter cover
Dust cloth
¢ Carton 2: Control unit and tonearm
Control unit
Audio cable
Turntable platter
Ground wire
Turntable platter cover knob
Screwdriver
Tonearm
Sub-weight
Head-shell assembly{head-shell
body + finger + fixing
screws(10mm x 2)+ Nuts(2), fixing
screws(15mmx 2, 22mm~x 2)]
Anti-skating thread
EP adaptor{overhang gauge}
Turntable platter fixing screws(3)
Turntable sheet replacement
screws(2)
Turntable platter cover fixing
screws(3)
Further, four absorbers are packed together
with the instruction manual
Tonearm
cover knob
~
XN
EP adaptor —_—_
Turntable platter fixing screws
Fig. 2
/
L-o7DIK) 5