Operation - Kenwood L-07D Instruction Manual

OPERATING INSTRUCTIONS
Ne
1. Check the stylus pressure, connections bet-
ween the turntable and control unit and
amplifier and control position of the
amplifier
2. Turn ON the power switch of the control
unit
The red LED above the power switch will
light
3. When the outer disc stabilizer DS-20 is us-
ed, press the dynamic parameter switch.
The red LED above the switch will light and
the dynamic parameter range is changed
from 18 ms to 15 ms
NOTE:
When only 1e inner stabilizer is used or
stabilizer is not used, do not press the dynamic
parameter switch.
4. Place a record on the turntable platter.
When playing an EP record with a large
center hole, use the EP adaptor
5. When playing 45 rpm records, press the
speed selector switch. When the power
switch is turned ON, the speed is set to
33-1/3 rpm automatically.
The speed is indicated by the speed in-
dicator.
6. Press the operation switch. The platter
starts turning and the speed indicator turns
from red to green when speed is stabilized.
7. Raise the elevation lever and place the
tonearm above the lead-in groove of the
record.
8. Lower the elevation lever. The stylus tip
gently drops onto the record and playback
starts.
Dynamic
parameter
Power switch switch
|
DYNAMIC
11 OFF
ParaMeTeR
1 18ms
2 ON POWER RANGE = 15ms
10
11
12.
DYNAMIC PARAMETER SWITCH
. After playback or to stop mid-way, raise the
~
elevation lever The stylus tip is gently rais-
ed from the record
Return the tonearm to the arm rest.
Press the operation switch to stop the plat-
ter.
Turn OFF the power switch of the control
unit
Speed indicator
Fig. 23
QUAR 2)
a
OPERATION SPEED
Operation Speed
switch selector
42 L-07DIK)