Kenwood L-07D Instruction Manual page 7

ASSEMBLY
1 Before assembly
2 Unpacking the turntable
Unpack the turntable and place it in a place
where there is room to work. At this time, do not
turn the four insulators.
3 Installation of the turntable platter
Install the turntable platter with the three fix-
ing screws
as shown
in Fig. 5 Carefully place
the turntable sheet on the platter
Ny 3
Se,
Turntable se 5
fixing screw
Fig. 5
4 Installation of the tonearm
1. Pass the attached audio cable through the
arm base hole and connect the cable to
the tonearm As the audio cable connec-
tor is of the screw lock type, tighten the
screw to lock the connector. (Fig. 6)
2. Align the tonearm height-adjusting gauge
with the arm rest support cut-off and
carefully insert the tonearm into the arm
base (Fig 7) Turn the height adjusting
handle counterclockwise (in the ''DOWN''
direction) four or five times to engage the
adjusting gear. (Fig. 8) Adjust the
tonearm height after installing the car-
tridge (refer to page 9)
NOTE:
1. One rotation of the tonearm height ad-
justing handle will lower/raise the
tonearm by approx O.1 mm.
2. Moving the turntable after locking the
tonearm will damage the tonearm's pivot.
Plug in to make connection
and tighten the screw to
lock the connector
Fig. 6
Align the tonearm height-
adjusting gauge with the
arm rest support cut-off
Align the pin with the
slot and insert
Turn the height adjusting
handle counter clockwise
{in the "DOWN" direction)
four or five times to
engage the adjusting gear
Fig. 8
L-O7DIK} 7