Operation - Energizer EZMT20V4A User Manual

6. OPERATION

6.1 CHARGING THE BATTERY PACK
IMPORTANT! The battery pack is not fully charged at the factory. Before attempting to
charge them, thoroughly read all of the safety instructions.
1) Assure that the charger you use is applicable to the battery pack.
2) Insert the charger into 220-240V~, 50-60Hz outlet. The indicator light with turn red to show
the power is connected.
3) Insert the battery into the slot of charger. Make sure the contact with the charger is correct.
4) The indicator light with turn green and flash when charging.
5) When fully charged, the indicator light changes to a solid green light.
6) Frequently monitor the charger and battery pack while connected.
7) Unplug the charger and disconnect it from the battery pack when finished.
8) Allow the battery pack to cool completely before using it.
9) Store the charger and battery pack indoors, out of reach of children.
NOTE: If the battery does not fit properly, disconnect it and confirm that the battery pack is
the correct model for this charger as shown on the specification chart. Do not charge any
other battery pack or any battery pack that does not securely fit the charger.
NOTE: If battery is hot after continuous use in the tool, allow it to cool down to room
temperature before charging. This will extend the life of your batteries.
NOTE: Remove battery pack from charger stand with your thumb or fingers, press the battery
release button in and pull the battery pack off at the same time.
6.2 BATTERY CAPACITY INDICATOR
There are battery capacity indicators on the battery pack, you can check the capacity status of the
battery if you squeeze the button. Before using the machine, please press switch trigger to check
if the battery is full enough for properly working.
WARNING! Before making any adjustments ensure this tool is switched off with the
direction of rotation selector in the center position
1) Remove the battery: press the battery release latch in and at the same time pull the battery pack off.
2) To insert the battery: push the battery pack into the contacts of the tool.
6.3 SWITCHING ON/OFF
1) To switch on the multi-function tool, press the on/off switch (2) forward into the on position.
2) To switch off the multi-function tool, press the on/off switch (2) backward into the off position.
13