Table of Contents
Advertisement
12.
If necessary, align the panels. → Page 39
Note: The gap between the worktop and the appliance
must not be closed by additional battens.
Thermal insulation strips must not be fitted to the side
panels of the surround unit.
27.11 For handleless kitchens with vertical
bar handle strips:
1.
Attach a suitable filling piece in order to cover any
sharp edges and to guarantee a safe installation.
2.
Pre-drill aluminium profiles to establish a screw con-
nection.
3.
Secure the appliance using a suitable screw.
27.12 Attaching the fastening elements
In order to attach the panels, the four fastening ele-
ments must be fitted beforehand.
1.
Push the eccentric forwards from the fastening ele-
ment
.
2.
Push the eccentric backwards from the fastening
element
.
a The eccentric breaks off.
3.
Push the eccentric backwards into the fastening ele-
ment
.
4.
Attach the red fastening elements at the top.
Attach the green fastening elements at the bottom.
5.
Slide in the fastening element at the bottom
press down at the top
27.13 Aligning the panels
ATTENTION!
Unsuitable tools may damage the surface of the appli-
ance.
▶
Only use plastic tools.
▶
Do not use pointed or sharp tools.
1.
Slide a plastic tool, e.g. one of the other fastening
elements, into the gap between the appliance and
the panel.
2.
Pull the tool from the appliance with panel; a click-
ing noise can be heard when this is loosened.
Installation instructions en
and
until it clicks into place.
39
Advertisement
Table of Contents
