Table of Contents
Advertisement
Note:
Further information:
19.4 Attaching the pull-out rail
Note: The pull-out rails only fit on the right or left. Make
sure when you fit them that you can pull them out to-
wards the front.
1.
Guide the pull-out rail with the rear retainer
below behind the two guide rods for the required
shelf position and keep it horizontal.
2.
Guide the rail lengthways to the rear to the guide
rods, and slide both retainers onto each lower rod.
In doing so, use the rear retainer
tical rod.
20 Appliance door
Appl i a n c e do o r
To clean the appliance door thoroughly, you can disas-
semble the appliance door.
20.1 Detaching the appliance door
WARNING ‒ Risk of injury!
Components inside the appliance door may have sharp
edges.
▶
Wear protective gloves.
The hinges on the appliance door move when the door
is opened and closed, which could trap your fingers.
▶
Keep your hands away from the hinges.
1.
Open the appliance door fully.
3.
from
4.
a The retainer clicks into place.
5.
to grip the ver-
Note:
Further information:
Press and hold PUSH
inwards
until the retainer
lower rod.
a
Release the PUSH tab.
Pull the pull-out rail out as far as it will go and slide
it back in.
Appliance door en
and swing the pull-out rail
is attached in the
23
Advertisement
Table of Contents
