Table of Contents
Advertisement
en Rails
2.
Pull the whole rail to the front
3.
Clean the rail.
→ "Cleaning products", Page 18
19.2 Attaching the rails
Notes
¡ The rails only fit on the right or left.
¡ For both rails, ensure that the curved rods are at the
front.
1.
First, push the rail into the middle of the rear
socket
until the rail rests against the cooking
compartment wall, and then push this back
2.
Push the rail into the front socket
also rests against the cooking compartment wall,
and then press this downwards
19.3 Removing the pull-out rail
WARNING ‒ Risk of burns!
The shelf supports get very hot
▶
Never touch the shelf supports when hot.
▶
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
ATTENTION!
The self-cleaning surfaces in the cooking compartment
may be damaged by detaching and attaching the pull-
out rails.
▶
Detach the rails before detaching or attaching the
pull-out rails.
Notes
¡ Depending on the appliance type, you must change
the basic settings for the telescopic rails for appli-
ances with rails and pull-out rails.
→ "Basic settings", Page 15
¡ The pull-out rails can be installed at any level as re-
quired.
22
and remove it.
.
until the rail
.
¡ If necessary, you can equip all levels with a pull-out
rail.
1.
Push on the side of the tab marked PUSH behind
the rail, and push the rail to the rear.
2.
Press and hold PUSH
wards
until the front retainer
a
3.
Pull the rail out towards the front.
4.
Remove the pull-out rail.
5.
Clean the pull-out rail.
→ "Cleaning products", Page 18
and swing the rail out-
is detached.
Advertisement
Table of Contents
