Table of Contents
Advertisement
en Installation instructions
2.
Removing the two transport locks
Press on the sloped surface on the rear of the
‒
transport lock
.
Press and hold the sloped surface and pull the
‒
transport lock upwards and out
3.
Unscrew the screws on the door handle a little
4.
Attach the door handle
The larger hole must be be directed inwards.
‒
Check whether the silicone base is between the
‒
panel and the door handle.
5.
Tighten the screws until the door handle is secured.
6.
Push the appliance in fully.
Do not kink or trap the connection cable, or route it
over sharp edges.
38
.
.
7.
Centre the appliance.
There must be an air gap of at least 4 mm between
the appliance and adjacent unit fronts.
8.
Attach the four fastening elements. → Page 39
.
9.
Screw the appliance into place.
10.
Push on the left- and right-hand panels at the height
of the fastening elements until a clicking sound is
heard.
The panel with the sticker is intended for the left-
‒
hand side of the inside.
a The panels are engaged.
11.
Check whether the left- and right-hand panels are
vertically aligned.
Advertisement
Table of Contents
