Add Racks Directly To The - Beckman Coulter AU5800 Manual

2
Place the set tray with racks on the rack set unit, and an empty collection tray on the rack
collection unit. Slide the rack stabilizing bar forward on the collection tray.
CAUTION
Verify the tray set indicators on the set tray and collection tray are in the correct
position according to the photos below. Reset the set tray or collection tray if
necessary.
Figure 6.2
1
1. Tray set indicator.
2. Correct tray set indicator position: A flat orange square indicates the orange switch is completely up and
the tray is flat on the rack set unit or rack collection unit.
3. Incorrect tray set indicator position: An orange square at an angle indicates the orange switch is not
completely up, and the tray is not flat on the rack set unit or rack collection unit.
3
Select
Start
6.2.4 Add Racks Directly to the System
When adding racks directly to the system, use the following procedure. Verify that the racks are set
in the correct direction.
PN B08501AB
.
Sample Programming and Processing
6.2 Prepare Racks for Analysis
2
3
6
6-3