Operation - Yamato CD 20 BL Instruction Manual

mod. CD 20 BL (cod. 83513)
Installing hook
The hook is convenient for temporarily hanging the tool. This can be installed on either right or left side of the
tool. To install the hook, insert it into a groove in the tool housing on either side and then secure it with a
screw. To remove, loosen the screw and then take it out.

OPERATION

CAUTION: Always insert the battery cartridge all
the way until it locks in place. If not, it may accidentally
fall out of the tool, causing injury to you or someone
around you.
CAUTION: When the speed comes down
extremely, reduce the load or stop the tool to avoid
the tool damage.
Hold the tool firmly with one hand on the grip and the
other hand on the bottom of the battery cartridge to
control the twisting action.
NOTICE: Do not cover vents, or it may cause over
heating and damage to the tool.
► 1. Vents
CAUTION: When installing the hook, always secure it with the
screw firmly. If not, the hook may come off from the tool and
result in the personal injury.
► 1. Groove 2. Hook 3. Screw