Indicator Lamps; Remaining Capacity; Charging Process - Yamato CD 20 BL Instruction Manual

mod. CD 20 BL (cod. 83513)
CAUTION: Always install the battery cartridge fully. If not, it may accidentally fall out of the tool,
causing injury to you or someone around you.
CAUTION: Do not install the battery cartridge forcibly. If the cartridge does not slide in easily, it is not
being inserted correctly.
Indicating the remaining battery Capacity

Indicator lamps

NOTE: Depending on the conditions of use and the ambient temperature, the indication may differ slightly
from the actual capacity.

Charging process

Start charging by inserting the battery into the charger slot and then inserting the charger plug into the power
charger, insert the battery pack paying attention to the charger pins as shown in the illustration.
During the charging process the charger feels warm to the touch. This is a normal phenomenon does not
indicate any problem.
Important: Always connect the charger to the battery first and then plug it into the wall socket. When unplugging,
do the reverse: first unplug the charger from the wall outlet and then disconnect it from the battery.
To remove the battery cartridge, slide it from the tool while
sliding the button on both side of the cartridge.
To install the battery cartridge, align the tongue on the battery
cartridge with the groove in the housing and slip it into place.
Insert it all the way until it locks in place with a little click.
► 1. Button 2. Battery cartridge
► 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indicate the
remaining battery capacity. The indicator lamps light up for few
seconds. Below for detail remaining capacity information.
Three green lights on
Two green lights on
One green light on
outlet. The charge indicator (C) will flash red while charging. The battery
and charger get very hot in the process. The charge indicator will flash
green to indicate that charging is complete.
Once charging is complete, disconnect the charger before removing the
.
battery
Note: To prevent the battery from being inserted incorrectly into the

Remaining capacity

Full Charged
Tra 30% e 60%
Tra 10% e 30%