Setting Up; Charging The Battery; Microsd - VOLTCRAFT WBP-110 Operating Instructions Manual

10 Setting up

10.1 Charging the battery

Be sure to charge the battery before using the thermal imaging camera for the first
time.
Open the dust cap (E) to access the USB-C
Plug one end of the USB cable (included) into the USB-C
the other end into a suitable USB-A power supply.
Short press the power button (A) to display the battery charge status.
Allow the battery to charge until the full battery status (
nect the USB charging cable.

10.2 MicroSD

First, open the dust cap (E) to access the microSD card slot.
Insert the microSD card in the direction shown on the cap. You should hear a
click if you have done this correctly.
Close the cap again.
You may need to restart the device by switching it off and on again so it can
recognise the SD card.
You may need to format the SD card before using it for the first time.
More information can be found in section 13.6 "Settings" under the menu item
"Reset" and in section 19 "Technical data".
Note:
Photos and videos can also be stored in the internal memory.
38
port.
®
port of the device and
®
) and then discon-