13 Menu settings
13.1 Gallery
1. From the main menu, press the left ◄ (F) or right ► (H) button to highlight
"Gallery".
2. Briefly press the OK button (G) to confirm.
3. Briefly press the power button (A) to hide the menu.
4. Use the left ◄ (F) and right ► (H) buttons to navigate to the desired screen-
shot/video.
5. After that, press the OK button (G) to select the image of choice. This submenu
allows you to edit the image (parameters/image mode/palette).
Refer to items 13.3, 13.4 and 13.5 below.
To save the changes, select the check mark symbol.
To discard the changes, select the x symbol.
13.2 Alarm
From the main menu, press the left ◄ (F) or right ► (H) button to highlight "Alarm".
Briefly press the OK button (G) to confirm. This submenu allows you to set the lower
and upper alarms.
To do this, use the left ◄ (F) and right ► (H) buttons and confirm your selection by
pressing the OK button (G).
To exit the alarm setup menu, briefly press the power button (A).
13.3 Parameter menu
From the main menu, press the left ◄ (F) or right ► (H) button to highlight "Pa-
rameters". After that, briefly press the OK button (G) to display the submenu "Pa-
rameters".
Use the left ◄ (F) and right ► (H) buttons to navigate in this submenu, and press
the OK button (G) to enter this menu. Here you can make the following settings:
13.3.1 Ambient temperature
The ambient temperature affects the thermal imaging camera's measurement. The
permissible temperature range is between -10 and 50 degrees Celsius.
42