Advertisement
PROGRAMMING
Program transmitters
The RCJ33 only responds to programmed secwave transmitters. In order to program a transmitter,
activate the programming mode, then press the rear PTx button on the transmitter and the transmitter
channel button to be programmed.
Operation
[Press button]
Indication
P
1x briefly
LED P flashes red
PTx Learning
button
1x briefly
Tx
Transmitter
LED P lights up
button
2 seconds red
1x briefly
To program in an RTC06/07 or RTI01, please proceed as described in the
respective instructions.
Deleting transmission codes
In delete mode, individual transmitters can be specifically deleted from the memory of the RCJ33.
Operation
Indication
[Press button]
P
1x long
LED P flashes quickly red
Tx
Transmitter
LED P lights up
button
2 seconds red
1x briefly
If the LED flashes very quickly for about 2 seconds when deleting, the transmitter button to be deleted
was not programmed. The receiver remains in delete mode for approx. 30 seconds.
Reset
Doing a RESET, all programmed transmission codes are deleted.
Operation
Indication
[Press button]
P 1x long
LED P flashes quickly red
P 1x long
LED P lights up
4 seconds red
A programming process can be cancelled by briefly pressing the P programming button several times.
Once the LED turns off, the receiver returned to standby.
EXPLANATION
LED indications
off
lights up
flashes
flashes quickly
GENERAL INFORMATION
Disposal
Waste electrical products should not be
disposed of with household waste!
Dispose of the waste product via a
collection point for electronic scrap or
via your specialist dealer.
Put the packaging material into the
recycling bins for cardboard, paper and
plastics.
Note
Programming mode activated
(approx. 30 sec.)
Transmitter in programming mode
Transmission code is programmed.
When the LED turns off, the receiver
is ready for operation.
Note
Delete mode activated (approx. 30 sec.)
Transmitter has been deleted.
When the LED turns off, the receiver
is ready for operation.
Note
Delete mode activated (approx. 30 sec.)
All transmission codes have been deleted.
When the LED turns off, the receiver
is ready for operation.
Press button
<
briefly (
2 s) = Press button for less than 2 seconds
>
long (
2 s)
= Press button longer than 2 seconds
Warranty
We will remedy defects on the device based on
material or production errors or exchange the de-
vice within the statutory warranty period.
Any unauthorized tampering with, or modifica-
tions to, the product shall render this warranty
null and void.
Conformity
Hereby, ELDAT EaS GmbH declares that the ra-
dio equipment type RCJ33 is in compliance with
Directive 2014/53/EU. The full text of the EU de-
claration of conformity is available at the following
internet address: www.eldat.de
< 2 s
< 2 s
< 2 s
>2 s
>2 s
Customer Service
If the device does not work properly despite pro-
per handling or in case of damage, please contact
the manufacturer or your retailer.
ELDAT EaS GmbH
Schmiedestraße 2
15745 Wildau
Germany
Phone:
+49 3375 9037-310
Internet: www.eldat.de
E-mail:
info@eldat.de
learning
button PTx
PTx-Taste
>2 s
Advertisement
