Chapter 2. Hardware Components; Front View; Chassis Front View; Node Front View - Lenovo ThinkSystem SD530 V3 System Configuration Manual

Table of Contents

Chapter 2. Hardware components

This section contains information about each of the components in the D3 Chassis and SD530 V3 node.

The following sections show the controls, LEDs, and connectors on the front of the D3 Chassis and SD530

V3 node.

The following illustrations show the front view of the chassis installed with nodes.

The ThinkSystem D3 Chassis can contain up to four 1U nodes or up to two 2U nodes.

Important:

• For proper cooling, each node tray must be installed with either a node or node tray fillers before the

nodes in the chassis are powered on.

• The installation of nodes must follow the sequence of the tray numbering.

Four 1U nodes

For four 1U nodes: the two nodes in the right trays (

The following illustration shows the front view of the chassis and respective node trays in the chassis.

Figure 1. Chassis front view with four 1U nodes

Node tray 3

Node tray 1

The following illustrations show the controls and connectors in the front view of the ThinkSystem SD530 V3

node. Depending on the specific configuration, some of the components or connectors might not be

supported.

Front view of the SD530 V3 node

See the following illustration for components and connectors in the front view of the ThinkSystem SD530 V3

node.

and

) must be installed upside down.

Node tray 4

Node tray 2

Table of Contents

Table of Contents

7dd3 7dda