Power Cords - Lenovo ThinkSystem SD530 V3 System Configuration Manual

Description
Rear I/O module
3
PCIe filler
4
PCIe riser filler
5
PCIe riser
6
PCIe adapter
7
GPU air duct
8
Power distribution board
9
Fan
10
System board
11
External diagnostics handset
12
M.2 drive
13
M.2 drive retainer
14
Memory module
15
CMOS battery (CR2032)
16

Power cords

Several power cords are available, depending on the country and region where the server is installed.
To view the power cords that are available for the server:
1. Go to:
http://dcsc.lenovo.com/#/
2. Click Preconfigured Model or Configure to order.
3. Enter the machine type and model for your server to display the configurator page.
4. Click Power ➙ Power Cables to see all line cords.
Notes:
• For your safety, a power cord with a grounded attachment plug is provided to use with this product. To
avoid electrical shock, always use the power cord and plug with a properly grounded outlet.
• Power cords for this product that are used in the United States and Canada are listed by Underwriter's
Laboratories (UL) and certified by the Canadian Standards Association (CSA).
• For units intended to be operated at 115 volts: Use a UL-listed and CSA-certified cord set consisting of a
minimum 18 AWG, Type SVT or SJT, three-conductor cord, a maximum of 15 feet in length and a parallel
blade, grounding-type attachment plug rated 15 amperes, 125 volts.
• For units intended to be operated at 230 volts (U.S. use): Use a UL-listed and CSA-certified cord set
consisting of a minimum 18 AWG, Type SVT or SJT, three-conductor cord, a maximum of 15 feet in length
and a tandem blade, grounding-type attachment plug rated 15 amperes, 250 volts.
• For units intended to be operated at 230 volts (outside the U.S.): Use a cord set with a grounding-type
attachment plug. The cord set should have the appropriate safety approvals for the country in which the
equipment will be installed.
• Power cords for a specific country or region are usually available only in that country or region.
Type Description
T1 Firmware and RoT security module
19
T1 E3.S drive filler
20
T1 E3.S drive
21
T2 E3.S drive backplane
22
T1
E3.S drive cage
23
T1 Node tray
24
T2 Screws
25
T1 Cables
26
F
1U performance heat sink and processor
27
carrier
T1 1U standard heat sink and processor carrier
28
T1 Heat sink support bracket
29
T1 Power bus bar
30
T1 Cable ducts
31
C
Type
F
T1
T1
T1
T2
F
T1
T1
F
F
F
T1
T1
.
Chapter 3 Parts list
45