Circulation Pump; Mechanical Thermostat - Teba therm T-17 Installation Manual

CAUTION! When filling, the installation has to be carried out from any point of the
installation other than the expansion tank and the other outlet on the side should be
closed with a blind plug, but the vapor output (water discharge) on the expansion
tank must not be closed.
While adding water to the expansion tank, please check the water level, fill the
water up to half of the expansion tank.

4.2.2 Circulation Pump

Circulation pump and bypass line should be installed to the input of the radiators of
the product as shown in (figure). The unshielded
the product, should be connected to the circulation pump as shown below.

4.2.3 Mechanical Thermostat

Your stove is equipped with a mechanical thermostat. Appropriate settings of the
mechanical thermostat is specified in the enclosed information page. In the stand-
by, you can save fuel and take advantage of optimal fuel energy if the recommended
settings are adhered to.
While Burning Stove: (Mechanical Thermostat Settings)
Max. Fuel
Fuel
Quantity
cable,
Mechanical thermostat
(Air passing through the
grate )
7
located at the (rear) part of
Glass Cleaning
Air - Condition