CAUTION: Fill the expansion tank halfway through water supply.
Before the activation of the stove, the labels (except the plate) on the stove and the
accessories in the ashtray or fire chamber needs to be removed, as it is only valid for
shipping protection.
5.3 COMBUSTION AND HEATING
First of all put 3-4 bricket wood in the fire chamber and put small pieces of wood or
paper to burn. All existing glass cleaning vents must be open. Then, after burning
the stove, close the fireplace chamber cover. For the air-flow control, thermostatic
regulation setting in the attached information page needs to be observed.
The stove should be burned carefully during the first use and the flame should be
kept as low as possible. If you burn it carefully, you will prevent the formation of
cracks in the insulating stones, damage the paint and deterioration of the material.
The smell caused by the protective paint on the stove is short-lived, so keep the
doors and windows open.
CAUTION: Our products should not be used to burn environmentally
hazardous waste.
5.3.1 Adding fuel
In addition to suitable fuel, enough chimney extraction and properly use of the stove
has an impact on glass cleaning. In this context, we recommend you to use wood in a
single layer and use wood to fill the width of the large fire chamber. When opening
the flame chamber cover, make sure that the air vent cover of the mechanical
thermostat is closed. After adding the fuel, the flame chamber cover should be
closed and the mechanical thermostat needs to be set.
5.3.2 Use during transition period
In the transitional season or by hot weather, problems may occur in the chimney
output (smoke) draft. To avoid damages in the transitional period, the product
should be operated with less fuel or should not be burned.
11