Circulation Pump; Mechanical Thermostat - Teba therm T-21 Manual

The expansion tank vapor output (water discharge) is used to expel the water
vapor caused by pressure from the stove. The water vapor expels by taking a line
from vapor output (water discharge) to the wet floor.
CAUTION! When filling, the installation has to be carried out from any point of the
installation other than the expansion tank and the other outlet on the side should
be closed with a blind plug, but the vapor output (water discharge) on the
expansion tank must not be closed.
While adding water to the expansion tank, please check the water level, fill the
water up to half of the expansion tank.

4.2.2 Circulation Pump

Circulation pump and bypass line should be installed to the input of the radiators
of the product as shown in (figure). The unshielded cable, located at the (rear)
part of the product, should be connected to the circulation pump as shown below.

4.2.3 Mechanical Thermostat

Your stove is equipped with a mechanical thermostat. Appropriate settings of the
mechanical thermostat is specified in the enclosed information page. In the stand-
by, you can save fuel and take advantage of optimal fuel energy if the
recommended settings are adhered to.
While Burning Stove: (Mechanical Thermostat Settings)
7