Troubleshooting - Raider RD-GLM16 User Manual

TROUBLESHOOTING

Issue
With the «START» key
the starter does not work
With the «START» key, the starter works,
but the engine does not start
The engine stops
Engine does not start with manual start
The manually started engine stops
Starting is difficult or engine misfires
Poor engine performance
during cutting
The engine stops when the vane
is turned on
Unusual vibrations
during work
Uncertain or ineffective braking
CAUTION! Malfunctions that cannot be rectified using this table can be rectified by an authorized
service center.
Do not undertake complex repair work if you do not have the necessary equipment or technical
knowledge.
The warranty is automatically voided and the manufacturer is not responsible if the repair is done
incorrectly.
Reason
Turn the key to «STOP» and look for the cause of the problem
Dead battery
Blown fuse
poor motor or frame grounding
The ground connections of the micros-
witches are disconnected
Poorly grounded starter motor
You are not ready to launch
incorrect fuel supply
faulty ignition
Turn the key to "STOP" and look for the cause of the problem:
Dead battery
Incorrectly connected battery
(poor contact)
The ground connections of the micros-
witches are disconnected
The motor is grounded incorrectly
The ground connections of the micros-
witches are disconnected
You are not ready to launch
Incorrect fuel supply
Misfire
The ground connections of the micros-
witches are disconnected
Carburetion failure
The travel speed is too high for the
cutting height
You are not ready to turn on the blade
The blade is unbalanced
The blade is loose
Fixing bolts are loose
the brake is not adjusted correctly
Correction
Recharge the battery
Replace the fuse (10A)
Check the connections of the black
ground wires.
Check the links
Check the grounding
Check that the conditions enabling the
start are met
-Check the fuel level in the tank
-Check throttle lever adjustment
-Check fuel filter and fuel wiring
-Check that the spark plug caps are
securely in place
Make sure the electrodes are clean and
have the correct gap
charge the battery
check the links
check the links
check the motor ground
check the links
check that the conditions enabling the
start are met
-Check the level in the tank
-Check throttle lever adjustment
-Check fuel filter and fuel wiring
check that the spark plug caps are
securely in place
Make sure the electrodes are clean and
have the correct gap
check the links
-Clean or replace the air filter
-Rinse the float chamber
-Empty the fuel tank and fill it with fresh
fuel
-Check and, if necessary, replace the
fuel filter
reduce the forward speed and/or raise
the cutting machine
check that safety requirements are met
contact an authorized service center
contact an authorized service center
check and tighten all engine and frame
mounting bolts
contact an authorized service center
77