Leveling The Cutting Deck; Fuse Change; Battery Maintenance - Raider RD-GLM16 User Manual

LEVELING THE CUTTING DECK

• The cutting machine must be properly adjusted to obtain a good cut
(fig. 31).
• If the cut is uneven, check the tire pressure.
• If this is not enough to achieve an even cut, please contact
authorized service center to adjust the alignment of the cutting machine.
TIRE PRESSURE
Regularly check the tire pressure, keeping it within the specified values (see Specifications).
WHEELS CHANGE
Stop the machine on a level surface and place a block under the frame support on the side where
the wheel is to be replaced. The wheels are held by a ring and a washer, which can be released
with a screwdriver (fig. 32A).
Note: If you need to replace one or both rear wheels, make sure they are the same diameter and
check that the cutting mechanism is horizontal to prevent uneven cutting.
IMPORTANT! Before reinstalling the wheel, apply grease to the axle. Put the ring and retaining
washer back in place.
TIRE REPLACEMENT AND REPAIR
All flat tire repairs or replacements must be performed by a tire repair expert in accordance with
the methods for the type of tire being used.
Use only certain tire sizes (see Specifications).

FUSE CHANGE

The machine is equipped with a fuse (fig. 33A). When it thunders, the machine stops, so in this case.
1. Open the engine cover.
2. Remove the fuse (fig.34) and replace the fuse with another one of the same capacity.
The fuse capacity is indicated on the fuse. The fuse should not
replace with another one that has a different capacity. If you can't find the reasons for
disconnection, consult an authorized service center.
3. Close the engine cover.

BATTERY MAINTENANCE

• The battery must be maintained carefully to ensure a long life.
• The machine's battery must always be charged: before using the machine for
first time after purchase; before leaving the machine for a long period of time; before
run the machine when it has not been used for a long period.
• Carefully read and follow the battery charging instructions. Failure to follow the instructions or
charge the battery may damage the batteries.
• A dropped battery should be charged as soon as possible.
• Replace the battery initially every 12 months, preferably before the start of the new season.
IMPORTANT! Recharging should be done using a DC battery charger. Other charging systems may
irreversibly damage the battery.
WARNING! Explosive and toxic fumes are released during battery charging. Charge the BG battery
in a well-ventilated area. DO NOT SMOKE AND KEEP AWAY FROM OPEN FLAMES AND SPARKS.
IMPORTANT! Never start the engine until the battery is fully charged! Make sure the key is in the OFF
position.
• The machine is supplied with a recharging connector (fig.35A), close to the battery, to be con-
nected to the connector for the special battery charger "CB02" (fig.36), supplied (if included) or on
request.
• This connector should only be used to connect to the "CB02" support charger.
• The charger is limited to charging only the charge-regulated lead-acid battery.
• Never use this charger for other types of batteries such as alkaline, lithium, carbon zinc or other
types not specified.
• The charging device should only be used under normal indoor conditions, not exposed to mois-
73