Table of Contents
Advertisement
LAUNCH
Crocodile clips
5
Back probe pins suite
6
Type A-Type B USB cable
7
Power adaptor
8
User manual
9
1.3 Technical Parameters
1. When used as Oscilloscope
Name
Channels
Bandwidth
Max. sample rate
Timebase
Acquisition mode
Storage depth
Coupling
www.diagtools.eu; info@diagtools.eu; Pernavas 43A-9, Riga, Latvia, LV-1009; +37129416069
EM101N New Energy Oscillograph Multimeter User Manual
Designed to connect the bare terminals or leads.
Used to connect sensor and BNC to 4mm Test Leads,
and can easily pierce the insulation of wires to allow for
automotive electrical measurements without causing
damage to the wires. Additionally, they can be used as
pin-tip probes while working with small circuit boards.
Used to connect EM101N and diagnostic tool, sending
signal acquired by EM101N to diagnostics tool to display
waveform.
Used to charge the EM101N with included USB cable.
2
10MHz
50MHz/s
200ns/div~10s/div
Normal sampling
240KB (for two channels)
DC, AC
2
Descriptions
Advertisement
Table of Contents
