Auto-Set; Menu Operations - Launch EM101N User Manual

LAUNCH
tested signal voltage direction is consistent with preset direction, and the value reaches trigger voltage,
the EM101N will be triggered and capture waveform.
Menu
Source
Trigger
In this mode, the user can set the trigger level by directly dragging the Level scroll bar or the icon
the right side of the waveform display area.

3.2.3 Auto-Set

The Oscilloscope has an auto-set feature that sets up the Oscilloscope automatically to display the input
signal in a best fit.
Tap Auto, the EM101N may change the current settings to display the signal. It automatically adjusts the
vertical and horizontal scaling, as well as the trigger coupling and position.

3.2.4 Menu Operations

1. Measure
The EM101N provides 6 parametric auto measurements. Tap Measure and the following screen will
appear:
Tap to select the desired measurement item. All selected items will be shown on the left side of the Clear
button.
www.diagtools.eu; info@diagtools.eu; Pernavas 43A-9, Riga, Latvia, LV-1009; +37129416069
EM101N New Energy Oscillograph Multimeter User Manual
Select channel source of triggered signal.
Level: The electrical level that signals shall exceed when capturing
waveform.
Rise: Trigger on rising edge.
Drop: Trigger on falling edge.
Close: Turning off trigger mode.
13
Comments/Settings
on