Connection - Launch EM101N User Manual

LAUNCH
Note: During auto calibration, please make sure no signal in input terminal of CH1 / CH2, otherwise it may
damage device.
Tap Menu -> User Settings, then tap Automatic Calibration.
Tap OK on the pop-up message box to start calibration. The LED on the EM101N starts flashing and the
prompt message "Calibrating, please wait" will appear on the upper left corner of the screen.
Note: While calibrating, no operations are allowed to perform until the calibration process is
successfully finished.
The self-calibration routine takes several minutes. After calibration is complete, the prompt message
"Correction successful" will pop up on the screen.
Tap OK to complete automatic calibration.

3.1.3 Connection

Testing Sensor:
1. Connect the BNC connector of the BNC to 4mm test lead to the CH1/CH2 (select number of channel
and channel No. according to actual situations), and plug the black (GND) and red (SIGNAL) 4mm
connectors into the Black (GND) and other color (SIGNAL) banana sockets of the 6-way breakout
leads (optional) respectively.
www.diagtools.eu; info@diagtools.eu; Pernavas 43A-9, Riga, Latvia, LV-1009; +37129416069
EM101N New Energy Oscillograph Multimeter User Manual
9