Table of Contents
Advertisement
LAUNCH
3.2 Operations
3.2.1 Channel Selection
A total of 3 channels are available: CH1, CH2 and REF (reference channel). Follow the methods to select
a channel:
A. Tap the channel tab shown on the right edge of the screen.
B. Tap
to select the target channel. This method is only applicable to the channel that is turned on.
Note: For better comparison and identification, each channel and waveform is marked in different color.
The EM101N can display multiple waveforms simultaneously, but only one waveform is allowed to
display at top. The top channel is called current channel displayed as
3.2.2 Channel Attributes & Trigger Setting
Channel attributes can be set via horizontal settings and vertical settings.
1. Horizontal Settings
User can change the horizontal time/division scale by tapping
time/division value from the pull-down list.
If the waveform acquisition is stopped, the time/division selector (
waveform.
2. Vertical Setup
This option allows you to adjust vertical scale and position, and other channel setup. Each channel has
one separate vertical menu, you can set individually.
Tap the target channel to call out the vertical setting option.
Option descriptions:
Menu
www.diagtools.eu; info@diagtools.eu; Pernavas 43A-9, Riga, Latvia, LV-1009; +37129416069
EM101N New Energy Oscillograph Multimeter User Manual
Comments/Settings
11
.
or
directly or by tapping the
/
) expands or compresses the
Advertisement
Table of Contents
