Launch EM101N User Manual page 12

LAUNCH
Help
4
Trigger information of current channel
5 Readouts represent storage depth, sample rate and
trigger information respectively.
Horizontal trigger position marker
6
Level scale of the Channel 2
7
Edge trigger level marker
8
Channel 1 vertical settings panel
9
Controls the amplitude of displayed signal. User can
change Invert, coupling and probe attenuation coefficient.
Channel 2 vertical settings panel
10
Controls the amplitude of displayed signal. User can
change Invert, coupling and probe attenuation coefficient.
Reference channel settings panel
11
Setup reference channel.
RUN/STOP/WAIT
 WAIT: All pre-triggered data has been acquired and
the EM101N is ready to accept a trigger.
12
 STOP: The EM101N has stopped acquiring waveform
data.
 RUN: The EM101N is running.
Auto
Automatically adjusts the vertical scale, horizontal scale
13
and trigger settings.
Single trigger
14
Capture one single trigger, complete acquisition, and
then stop.
Horizontal setting
15
Control the time base.
Quick save
Quickly saves the measured waveform of current
16
channel.
To modify save path and file type, go into Menu -> Save.
Channel selection button
17
www.diagtools.eu; info@diagtools.eu; Pernavas 43A-9, Riga, Latvia, LV-1009; +37129416069
EM101N New Energy Oscillograph Multimeter User Manual
7
Check detailed operation
instructions of application.
Displays working status.
Tap once - Turns on the
channel and sets it as the
current channel.
Tap twice - Calls out the
channel vertical settings.
Tap three times - Turns
off the channel.
Tap this button to start auto
setup function.
Tap this button once, the