Table of Contents
Advertisement
Indoor Unit Installation
Recommended Minimum Service Clearances
Mounting the Indoor Unit
3.
4.
16
1 6
1.
( 4 0
i n .
6 m
2.
m )
Vitocal 100-AW AM2V Installation, Service and Operating
Recommended minimum service clearances
For typical installation, it is recommended to install
the indoor unit with the clearances shown in the
illustration.
A - 12 in. (300 mm)
B - 20 in. (500 mm)
Front Clearance 39 in. (1000 mm)
These dimensions reflect the recommended service
clearance for the indoor unit only, ensure adequate
clearance is left for the installation of piping and
electrical connections.
Minimum Clearances to Combustibles
Top
Front
0
0 AL, CL
AL= Alcove
CL= Closet
The indoor unit can be wall-mounted on a concrete wall.
Note: The enclosed screws and rawl plugs are
only suitable for concrete. For other construction
materials, use bolts and anchors that are suitable
for 100 lb. (46 kg) loads.
Installation of mounting bracket on brick/concrete wall:
1. Mark out the rawl plug holes.
2. Drill holes ne in. (n10 mm) and insert the rawl
plugs supplied.
3. Fit the wall mounting bracket with the screws
supplied.
4. Mount the indoor unit on the wall mounting
bracket. Ensure that both tabs have locked into
the indoor unit.
Note: Check the condition of the wall where the
indoor unit is to be installed. For the suitability
of the supplied rawl plugs for various building
materials, see the manufacturer's instructions. For
other construction materials, use fixing materials
with sufficient load bearing capacity.
1
CAUTION
Whichever mounting method is used, ensure that
the bracket is tightly and securely fastened to wall.
Failure to secure indoor unit properly could cause
indoor unit to loosen, posing a severe safety hazard.
Rear
Left
Right
0
0
0
Advertisement
Table of Contents
