Table of Contents
Advertisement
114
Driving and parking
When Autohold is activated, the driver in-
formation display displays the green indi-
cator lamp
.
When the vehicle is shifted to re-
verse
, Autohold is not functional.
Autohold is automatically switched to
electric parking brake when:
● The driver releases the seat belt or
opens the driver's door.
● The Autohold time is exceeded (approx-
imately 10 minutes).
● Shifting to park
Press the brake pedal deeply to acti-
vate this function, and press the
brake pedal deeply again to deacti-
vate this function.
Disable Autohold when using an au-
tomatic car washer.
Cornering Brake Control
NOTE
Cornering Brake Control is only an assis-
tance system, and the driver must al-
ways maintain control of the vehicle and
take full responsibility for the safe driv-
ing of the vehicle.
Cornering Brake Control can control the
braking pressure on the inner wheels
when the vehicle is braking at the curve to
prevent the inner wheels from locking up
too early and improve the driving stability
of the vehicle.
Hill Assist
Hill Assist can help you start on the hill and
prevent the vehicle from slipping back-
ward. After releasing the brake pedal, Hill
Assist can keep the vehicle stopped on the
hill for about 2 seconds.
Hill Assist works even when Automatic
Parking Assist is disabled.
.
NOTE Notes on Hill Assist
Hill Assist cannot replace the parking
brake. Shift to park
the vehicle.
Press the brake pedal immediately when
the vehicle slips backward. Hill Assist
cannot completely prevent the vehicle
from slipping backward from a steep hill
under full load or on all road conditions.
Hill Descent Control (HDC)
Hill Descent Control can control the speed
through automatic braking intervention.
This function is especially useful when
going down a steep slope, especially when
the terrain is rough, slippery and
pockmarked.
At the same time, you can also press the
accelerator pedal to temporarily increase
the downhill speed, or press the brake
pedal to slow down or stop at any time.
Hill Descent Control is an aid, which
cannot handle all situations or road
conditions. The driver is always re-
sponsible for driving the vehicle
safely.
Enabling/disabling Hill Descent Control
>
● Tap
to enable/disable Hill
Descent Control.
When Hill Descent Control is in the ready
mode or when the vehicle speed is below
60 km/h(38 mph), the grey/white indicator
on the driver information display
illuminates.
When Hill Descent Control is activated, the
green indicator
mation display illuminates.
This function can only be enabled
when the vehicle runs downhill at
low speed on a steep slope.
When the vehicle speed is higher
than 60 km/h(38 mph), the system
automatically disables the function.
After the Hill Descent Control is dis-
abled, the braking force will gradu-
ally decrease until it disappears.
when you leave
on the driver infor-
Advertisement
Table of Contents
