Table of Contents
Advertisement
96
Driving and parking
Driving
Notes on electric vehicles
WARNING Risk of chemical burns and
poisoning from damaged high volt-
age battery
If the housing of the high voltage bat-
tery has been damaged, electrolyte and
gases may leak out.
► Prevent battery acid from contacting
with the skin, eyes or clothing.
► Immediately rinse electrolyte
splashes off with water and seek
medical attention straight away.
WARNING Risk of explosion from ex-
cessive internal pressure of the high
voltage battery
In the event of a vehicle fire, the internal
pressure of the high voltage battery
could exceed the critical value. In this
case, flammable gas may escape and
may be ignited.
► Stop the charging process immedi-
ately in case of unusual odours,
smoke or burn marks.
► Keep away from dangerous areas im-
mediately, and call the fire service.
Observe the following notes on vehicle
noise emission and low speed warning:
● The vehicle is equipped with a pure
electric drive system, which generates
significantly less noise comparing to
gas powered vehicles.
Therefore, the vehicle is equipped with
a low speed warning function.
● When the vehicle moves forward or
backward at a speed lower than 20 km/
h(13 mph), the low speed warning alerts
pedestrians.
This helps other road users (particularly
pedestrians and cyclists) to hear your
vehicle better.
● When the vehicle moves at a speed over
20 km/h(13 mph), the low speed warning
is switched off.
● Despite the low speed warning, in some
cases pedestrians or other vehicles may
not be able to hear your vehicle moving,
and it is always your responsibility to
drive your vehicle safely.
● The low speed warning is turned off
when the vehicle is stationary.
Energy Regenerative Braking
When the driver releases the accelerator
pedal or presses the brake pedal, the ve-
hicle can recover the mechanical energy to
charge the high voltage battery.
Regeneration with accelerator pedal
Release the accelerator pedal, the vehicle
brakes, and the energy flow recovery sta-
tus is displayed on the driver information
display.
Regeneration with brake pedal
Press the brake pedal, the vehicle brakes,
and the energy flow recovery status is dis-
played on the driver information display.
Energy Regenerative Braking may be lim-
ited for the following reasons:
● The gear is in reverse
● Motor torque limit.
● The high voltage battery is fully
charged.
● Speed limit, Energy Regenerative Brak-
ing is not available when the vehicle
speed is lower than a certain value.
Adjust the energy regeneration level of
Energy Regenerative Braking
>
● Tap
Energy Regenerative Braking
to adjust the energy regeneration level
of Energy Regenerative Braking.
● Enter the setting interface:
>
Quick Controls
Tap
generative Braking
regeneration level of Energy Regenera-
tive Braking.
Swipe leftward from the right on the
centre display or tap
>
Controls
Regenerative Braking
just the regenerative braking level as
necessary.
.
>
Energy Re-
to adjust the energy
>
>
Quick
to ad-
Advertisement
Table of Contents
