Operation - Husqvarna BGS 250 Operator's Manual

To do a check of the ON and OFF buttons
1. Push down the handle lightly to lift the grinding
head from the surface, approximately 1 mm. This
decreases the pressure against the surface. Do not
lift the grinding head fully from the surface.
2. Push the ON button to start the product.
3. Wait for 5 seconds to let the product operate at idle
speed.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
To adjust the handle and the handlebar
WARNING:
the handle and the handlebar. Make sure
that the handle and the handlebar locks into
position. The moving parts can cause injury.
10

Operation

Before you operate the
Be careful when you adjust
4. Push the OFF button.
5. Make sure that the motor stops.
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product. Save all warnings and instructions
for future operations.
• Keep all parts in good condition and make sure that
all fixtures are correctly tightened.
• Do not use a product that is damaged or does
not operate correctly. Do the safety checks,
maintenance and the servicing as given in this
manual. All other maintenance work must be done
by an approved servicing dealer.
• Stop the product and disconnect the power plug
when you replace the diamond tools. Push the OFF
button to stop the product.
• Do the inspection and/or maintenance with the motor
stopped and the power plug disconnected.
• Do the maintenance to make sure that the product
operates correctly. Refer to
16 .
Set the handle height as close as possible to the height
of the operators hip. During operation the product can
pull to the side. The hip of the operator can help to stop
this movement to the side.
Read the warning
Maintenance on page
2363 - 002 - 12.03.2024