Listening To Tapes.19 - Panasonic SC-AK27 Operating Instructions Manual

Listening to tapes
Types of tapes which can be played correctly:
The unit automatically identifies the type of tape.
NORMAL POSITIONATYPE I
o
HIGH POSITION/TYPE II
o
METAL POSITION/TYPE IV 0
You can use either deck 1 or deck 2 for tape playback.
□
Press [TAPE].
The power will come on automatically.
Press
[±
DECK 1 OPEN] or
[±
DECK 2 OPEN] and
insert the tape.
Insert the tape with the exposed tape facing down.
Close the holder by hand.
Press [REV MODE] to select the reverse mode.
Every time you press the button:
r-o-co
*_i
X : One side is played, then playback stops automatically.
2D : Both sides (front side -► reverse side) are played one
time each, then playback stops automatically.
CUD : Both sides are played 8 times each, then playback stops
automatically.
Press [◄] or [►] to start playback.
► : The forward side (front side) will play.
M : The reverse side will play.
Adjust the volume level.
To stop tape playback
Press [■].
To change the deck to be used Q
Press (TAPE DECK1/2] to select the deck you want to use when you
load cassettes into both decks.
To listen to 2 tapes consecutively
Load a tape into each deck and select "CZ2*- Both tapes will be
played 8 times each.
UHEI
Playback is momentarily interrupted while playing back tapes, if you
open the other deck.
To fast-forward or rewind the tape □
Press or [►►/►►!] in the stop mode.
Tape direction To rewind
To fast-forward
T>" \\«/«) [►►/►►I]
"<r [«◄/◄◄]
To find the beginning of a program Q
(TPS: Tape Program Sensor)
Press [«◄/<*«] or [►►/►►!] during play.
Tape direction
(To play the current
tune from the
beginning)
(To play the next
tune from the
beginning)
"t>"
$<+*«]
[►►/►►I]
"<T
[►►/►►I]
Note
The TPS function searches for silent parts of about 4 seconds in
length which are normally found between tunes. As a result, it may not
function property in the following cases:
• With short silent parts
• When noise occurs between tunes
• With silent parts found within tunes