Table of Contents
Advertisement
Listening to Tapes
Either tape deck 1 or tape deck 2 can be used
tor tape playback by following the same steps.
Carry out the steps 1 and 2 of "Standard Operations" on page
20
.
1 Press the eject button, and then insert the
cassette to be used for playback.
(The part of the cassette where the tape is
expo^ should face down-ward.)
0
U
0
2 Press the Dolby noise reduction button to set
the Dolby NR mode B or C In which the tape
was recorded.
The Dolby noise reduction indicator (B or C) will illuminate.
•If the tape was not recorded in a Dolby NR mode, press the
Dolby noise reduction button again to go off the Dolby noise
reduction indicator.
3 Select the reverse mode.
Each time the reverse mode button is pressed, one of the
three reverse mode indicators () will be
alternately di^layed.
7
^ One side only will be played, and then the tape will
automatically stop.
Both sides will be piayed 8 times, then the tape will
automatically stop.
CJO (When a cassette is loaded in only one ceck.)
Both sides will be played, then the tape will automati¬
cally stop.
(forward side-» reverse side)
4 start playing the tape.
The forward side (front side) will be played.
The reverse side will be played.
•When the tapes are loaded in both decks, press the deck
1/deck 2 selector to select the deck to be used.
•To reset the tape counter (000), first press 8ie deck 1 /ded( 2
selector to select the deck and press the counter reset
button.
■ To stop tape playback
Press the stop button.
■ Auto tape selector function
This function automaticaliy identifies the kind of tape loaded
(rtormal, chrome, or metal), and sets the bias (for recording) and
equalization accordingly.
•Types of tapes that can be played : normal, chrome, metal.
-
28
-
Advertisement
Table of Contents
