Maintenance, Storage & Winterization; Technical Data - GRE VSG75 Instruction Manual

Variable speed swimming pool pump
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
6. MAINTENANCE / STORAGE & WINTERIZATION:
Maintenance
• Clean strainer basket regularly. Do NOT strike basket to clean. Inspect strainer cover gasket regularly and re-
place as necessary.
• Pumps have self-lubricating motor bearings and shaft seals. No lubrication is necessary.
• Keep motor clean. Do NOT use water to hose off motor.
• Occasionally, shaft seals must be replaced, due to wear or damage. Replace with genuine seal assembly kit.
Storage & Winterization
WARNING – Separation or Explosion Hazard.
• Do not purge the system with compressed air. Purging the system with compressed air can cause components
to explode, with risk of severe injury or death to anyone nearby. Use only a low pressure (below 5 PSI), high
volume blower when air purging the pump, filter, or piping.
ATTENTION
– Allowing the pump to freeze will void the warranty.
– Use ONLY propylene glycol as antifreeze in your pool/spa system. Propylene glycol is nontoxic and will not
damage plastic system components; other anti-freezes are highly toxic and may damage plastic components in
the system.
• Drain all water from pump and piping when expecting freezing temperatures or when storing pump for a long
time (see instructions below).
• Keep pump dry and covered during storage. To avoid condensation/corrosion problems, do NOT cover or wrap
pump with plastic film or bags.
STORING PUMP FOR WINTERIZATION
WARNING – To avoid dangerous or fatal electrical shock hazard, turn OFF power to motor before draining
pump. Failure to disconnect power may result in serious personal injury or death.
• Drain water level below all inlets to the pool.
• Remove drain plugs from bottom of strainer body, and remove strainer cover from strainer housing.
• Disconnect pump from mounting pad, wiring system and plumbing system.
• Once the pump is empty of water, re-install the strainer cover and drain plugs. Store pump in a dry area.

7. TECHNICAL DATA:

Code Input Power
Voltage
Hertz Frequency
Max Head Max Flow Rate Wire Size
VSG75
750 W
230V 50Hz
50Hz
14 m.c.w.
20 m3/h
H07RN-F
14
Instruction manual
- VARIABLE SPEED SWIMMING POOL PUMP

Advertisement

Table of Contents
loading

Table of Contents