Yamaha RX-V3300 Owner's Manual page 31

LEFT
SUBWOOFER
LEFT SURROUND
REAR CENTER
The test tone is heard from the left main speaker,
center speaker, right main speaker, right rear speaker,
rear center speaker, left rear speaker and subwoofer
in order. The tone is produced for 2.5 seconds each
time.
The state of the test tone output is also shown on the
monitor by an image of the audio listening room.
This is convenient for adjusting each speaker level.
Front panel display also indicates from which
speaker the test tone is output in the order of
TEST LEFT¡TEST CENTER¡TEST RIGHT¡
TEST R SUR.¡TEST REAR CNTR¡TEST L SUR.
¡TEST SUBWOOFER
Note
• If the test tone cannot be heard, turn down the volume, set this
unit in the standby mode and check the speaker connections.
3
Press –/+ repeatedly to
adjust the output level of
the effect speakers so that
the output level coming
from each speaker is the
same.
While adjusting, the test tone is heard from the
selected speaker.
Note
• Main L/R speaker level cannot be adjusted by itself. Use
VOLUME to adjust the main volume.
4
When the adjustment is
complete, press TEST.
To enter the "TEST DSP"
mode, press TEST once.
To stop the test tone, press
TEST twice.
RIGHT
CENTER
RIGHT SURROUND
TEST
ADJUSTING THE SPEAKER OUTPUT LEVELS
Notes
• If "1A CENTER SP" on the SET MENU is set to NONE, the
center channel sound is automatically output from the left and
right main speakers.
• If "1C REAR L/R SP" on the SET MENU is set to NONE, the
output level of the rear right, left and center speakers cannot be
adjusted in step 3. The test tone will be circulated in the order
of LEFT¡CENTER¡RIGHT¡SUBWOOFER¡LEFT...,
skipping the rear right and left speakers and the rear center
speaker.
• If "1D REAR CT SP" on the SET MENU is set to NONE, the
output level of the rear center speaker cannot be adjusted in
step 3. The test tone will be circulated in the order of
LEFT¡CENTER¡RIGHT¡RIGHT SURROUND¡LEFT
SURROUND¡SUBWOOFER¡LEFT ..., skipping the rear
center speaker.
• If "1E LFE/BASS OUT" on the SET MENU is set to MAIN,
the output level of the subwoofer cannot be adjusted. The test
tone will be circulated in the order of LEFT¡CENTER¡
RIGHT¡RIGHT SURROUND¡REAR CENTER¡LEFT
SURROUND¡LEFT..., skipping the subwoofer.
y
• It is not necessary to readjust the speaker level once it is set as
long as you do not change the speakers. You can enjoy listening
to or watching the input source with the desired volume by
adjusting the volume key.
• You can increase the output levels of the effect speakers
(center, left rear and right rear and rear center) to +10 dB. If the
output level of these speakers is lower than that of the main
speakers even after you have increased the output level of these
speakers up to +10 dB, set "1G MAIN LEVEL" on the SET
MENU to –10 dB (see page 64). This setting decreases the
main speaker output level to about one-third of the normal
level. After you have set "1G MAIN LEVEL" on the SET
MENU to –10 dB, adjust the levels for the center and rear
speakers again.
CONNECTIONS
27